#Trusted platform module windows 10 t410 driver#
Unfortunetely, I was completely unable to find any separate installable driver for Windows to properly detect the device and use it instead of the buitin Windows driver. It may also be an issue with the BIOS or UEFI driver in the motherboard, or the motherboard does not have a UEFI driver for the module, only a legacy BIOS driver, and the TPM does not work when booting in UEFI mode because it is not enumerated by the UEFI SLB9665TT2.0 chip) and which are those made for Gigabyte and Asus motherboard. This is most probably a bug in the builtin TPM driver coming with Windows itself, not compatible for example with a range of TPM modules made by Infineon (notably those using the Infineon You need to reset it a first time for less than 1/2 ms, then wait a bit, then reset it a second time and wait again: if you don't wait that time before you start sending other commands to it, the device will enter in self-protection mode and won't listen any Most probably Windows is not respecting the specs of the device and is trying to reset it too fast (TPM modules include a self-protection: It seems that we only see the TPM 2.0 transiently, then the device rapidely goes to some protection mode. If you have feedback for TechNet Subscriber Support, have the same issue. Please remember to mark the replies as answers if they help. We will try to analyze the log deeply for you. Once the log is collected, upload the log to OneDrive and paste the link here. HKLM\SYSTEM\CurrentControlSet\Control\WMI\Autologger\Tpm /v Start /t REG_DWORD /d 0 /f To disable TPM logging, from an elevated command prompt, type: Log files start with 'tpm*' from '%SystemRoot%\System32\LogFiles\WMI' Temporarily stop the TPM driver logging and flush the buffer: 'logman stop tpm -ets'ĥ. Reg delete HKLM\SYSTEM\CurrentControlSet\Control\WMI\Autologger\Tpm /v FileCounter /fĬhange to the directory '%SystemRoot%\System32\LogFiles\WMI’ Reg delete HKLM\SYSTEM\CurrentControlSet\Control\WMI\Autologger\Tpm /v FileMax /f Reg add HKLM\SYSTEM\CurrentControlSet\Control\WMI\Autologger\Tpm /v LogFileMode /t REG_DWORD /d 0x10000004 /f Reg add HKLM\SYSTEM\CurrentControlSet\Control\WMI\Autologger\Tpm /v Start /t REG_DWORD /d 1 /f From an elevated command prompt, run the following commands: Please try to enable the TPM log to collect more information to troubleshoot this issue.ġ.